Plaster M16 High Resistance
REVOCO M16 HIGH-STRENGTH mortar, supplied by Aymar SAU, is an industrial mortar made from cement, lime, marble aggregates, and special additives that give it good waterproofing and breathability; it can be applied by hand or using a spray machine.
It consists of crushed marble aggregates for construction, cement, calcium hydroxide, slaked air lime, and organic and inorganic additives designed to improve the workability and properties of the mortar.
- Application field
- Instructions of use
Mortar Plaster M16 HIGH-STRENGTH mortar is designed for interior and exterior plastering and rendering. Ideal for use on concrete blocks and existing plaster. Particularly suitable for both new construction and the renovation of older buildings where high surface strength is required.
This product is suitable for forming non-load-bearing PN panels with a reinforced EPS core and can be applied over an EPS substrate.
- Substrate preparation: clean and dampen the substrates before application. The substrate must be fully set, strong, sound, and free from dust, paint, oil, etc.
- Mixing instructions: add clean tap water, mix for 2 minutes, leave to stand for about 3 minutes, then mix again until a smooth, lump-free paste is obtained.
- Application of the product: spread the product onto the substrate using a trowel or machine and smooth it out. Wait 1 to 3 hours before finishing the surface. Apply two coats if applying directly to a brick wall.
